MINOLTA-QMS PagePro 9100 User Manual page 152

High-capacity input feeder (HCIF)
With these characteristics...
On a hard, flat, stable, level (±1° or
less slant at any point around the
machine).
Close to an easily accessible
grounded power supply (on an
exclusively dedicated power outlet)
that meets printer specifications.
Near your computer. At the length
6.5' (2 m) or less for an IEEE 1284
bidirectional parallel connection.
With enough space to allow
adequate ventillation and easy
servicing.
With an ambient temperature range
of 50°–90° F (10°–32° C) and
relative humidity range of 15%–85%
(noncondensating).
At an altitude of 0–10,170'
(0–3,100m).
5 "
A surface can be tested for levelness with a standard round pencil.
If the pencil rolls, the surface is not level. Clear the area of any
obstruction or items such as cables that might prevent the printer
from sitting directly on the flat, level surface.
„
If the printer is located in a cold room that is rapidly heated, or if the printer
is moved from a cold place to a warm, humid place, condensation may
occur within the printer, degrading print quality. If this occurs, allow the
printer to adapt to the environment for about one hour before use.
„
If using a humidifier or water vaporizer in the room with the printer, use
only purified or distilled water. Impurities in the water may be released into
the air, where they can accumulate inside the printer and cause degraded
printer output.
Attention
For products installed outside North America, do not connect the
groundwire to gas or water pipes or grounding for telephones.
146
20.25 lbs (9.19 kg) each (up to three
available)
But away from...
Direct sunlight. Heating and cooling
sources, extreme temperature or
humidity changes, wind, and dust.
Open flames or items that can easily
burn.
A connection to the same electrical
circuit as high-current machines.
Noise-generating equipment, such
as a copier or air conditioner, and
strong magnetic or electromagnetic
fields, such as a refrigerator.
Water, water pipes, liquid (drink)
containers, and corrosive chemicals
or vapors, such as ammonia.
Small, loose metal parts, such as
paper clips and staples.
Excessive vibration.
Requirements