MINOLTA-QMS PagePro 9100 User Manual page 126

increasing the memory in the Disk Cache, refer to the (in PDF on the
Software Utilities CD-ROM) .
What's in the SCSI Interface Kit?
An optional SCSI interface kit includes the following:
SCSI interface card
SCSI interface card ribbon cable
Connector face plate
Two larger screws, two smaller screws
Installing a SCSI Interface
Attention
It's very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 98. In addition,
always handle circuit boards by the edges only.
1
Turn off the printer, and then disconnect the power cord and all interface
cables from the printer.
2
Remove the controller board.
Loosen four screws, and pull
the controller board
from the printer.
3
Position the controller board
on a flat surface so it lies flat
and the I/O connector panel
is facing you.
4
Remove the two screws hold-
ing the metal plate over the
SCSI interface opening.
You can dispose of the metal
plate and screws according to
local regulations.
5
Attach the ribbon cable to its connector on the SCSI interface card.
a
Position the SCSI interface card so that its ribbon cable connector
aligns with the SCSI connector on the controller board.
120 SCSI Interface