Audio Connections; Connecting To Audio Equipment; Playing 2 Channel Audio - Sharp DV-NC55U Operation Manual

Audio Connections

Connecting to Audio Equipment

Connecting the Unit to audio equipment provides normal stereo sound plus powerful stereo sound enhanced
by Dolby Digital (5.1 channel) and DTS.

Playing 2 channel audio

I Analog Connection
DVD OUT
AV 2 OUT
DIGITAL
AUDIO
S-VIDEO R
AUDIO
L
(White)
(White)
Audio equipment, etc.
Jack and Plug Colors
Audio Left: White
Audio Right: Red
• When connecting the audio equipment to the analog
connection, we recommend that you set the
"COMPRESSION" in "AUDIO SETUP" to "OFF" (See
page 44).
Digital Connection to an MD to Record a CD
When you are using a digital connection to record the
contents of a CD to an MD, the track numbers of the CD
may not match the track numbers recorded to the MD.
24
DVD/VCR VCR
AV 1 OUT AV 1 IN IN FROM
ANTENNA
R
R
AUDIO AUDIO
UHF/VHF
L L
CATV
( MONO )
OUT TO TV
OUTPUT
VIDEO VIDEO
CHANNEL
3 4
To AUDIO
(Red)
output jacks
VIDEO/AUDIO cable
(supplied)
To amplifier
audio input jacks
(Red)
I Digital Connection
DVD OUT
AV 2 OUT
DIGITAL
AUDIO
S-VIDEO R
AUDIO
L
To DIGITAL AUDIO
output jack
Coaxial digital cable
(commercially available)
Audio equipment with
coaxial digital input jack
Important!
• When connecting the audio equipment to the
digital connection, set the "
"AUDIO SETUP" to "D-PCM" (See page 45).
• No VCR sound will come out from the DIGITAL AUDIO
output jack.
I Digital Connection to Audio Equipment or MD Player
without a Dolby Digital Decoder
• Audio CD
Play the disc as you normally would, with the audio mode set
to "L+R" (See page 64). With a digital connection, audio of a
disc recorded with DTS sounds abnormal in this case.
• DVD Video Disc
The digital connection illustrated above shows connection to
audio equipment that is not equipped with a decoder.
Because of this, it cannot produce 5.1 channel sound when
playing a DVD whose audio track is recorded in Dolby Digital
(5.1 channel), Dolby Surround (Pro Logic) or DTS. To play the
audio on such a DVD, you must configure a digital connection
with an audio processor or amplifier equipped with a decoder
for the type of audio on the DVD you are attempting to play
(See page 45). If you do not have an audio processor or
amplifier equipped with the proper decoder, use a 2-channel
analog (Down Mix) connection (See left). Note that discs
recorded with Linear PCM audio should play normally using
the digital connection illustrated above.
DVD/VCR VCR
AV 1 OUT AV 1 IN IN FROM
ANTENNA
R
R
AUDIO AUDIO
UHF/VHF
L L
CATV
( MONO )
OUT TO TV
OUTPUT
VIDEO VIDEO
CHANNEL
3 4
To coaxial
digital input jack
DIGITAL" in