Sharp DV-NC55U Operation Manual page 21

Connection with cable box
• Connect as shown below. With this connection, it is possible to record descrambled CATV signals.
Cable Box
IN OUT
From
CATV
system
• If the cable box is turned off, it will not output any signals, thus making it impossible to record or view a program from
the CATV system.
• In the case of the above connections, it is not possible to change channels using the Unit's remote control. Only the
cable box can be used to change channels.
• Only one channel at a time can be programmed for recording programs with the timer. It is not possible to watch a TV
program different from the one being recorded.
• Depending on which terminals the TV has, a separate combiner (mixer) or separator (splitter) may be necessary.
After the Connection
Plug in the power cord of the TV. Then go to EZ Set Up (See page 26).
• Connect as shown below. With this connection, it is not possible to record CATV programs which have been
scrambled, but is possible to record one channel and watch the other one.
From CATV system
Unit's Rear
• With the above connection, CH '/" of the Unit or the number buttons on the remote control can be used to select
channels.
• Depending on which jacks the TV has, a combiner (mixer) or separator (splitter) may be necessary.
• To record one channel and watch another, the Unit must be set to the TV mode.
After the Connection
Plug in the power cord of the TV. Then go to EZ Set Up (See page 26).
Coaxial cable
(Not supplied)
S-VIDEO
Unit's Rear
DVD/VCR
AV 1 OUT AV 1 IN IN FROM
DVD OUT
ANTENNA
AV 2 OUT
R R
DIGITAL
AUDIO AUDIO
AUDIO
UHF/VHF
L L
CATV
(MONO)
OUT TO TV
S-VIDEO R
VIDEO VIDEO
AUDIO
L
DVD/VCR VCR
AV 1 IN IN FROM
AV 1 OUT
DVD OUT
ANTENNA
AV 2 OUT
R R
DIGITAL AUDIO AUDIO
AUDIO
UHF/VHF
L L CATV
(MONO)
OUT TO TV
R
VIDEO VIDEO
AUDIO
L
VCR
OUTPUT
CHANNEL
3 4
Coaxial
cable (Supplied)
Cable TV Connections
OUTPUT
CHANNEL
3 4
Coaxial
cable
(Supplied)
Cable Box
IN OUT
Coaxial cable
(Not supplied)
TV Rear
ANT/CABLE
TV Rear
ANT/CABLE
21