Table Of Contents - Real Time Devices AD1200 User Manual

Table of Contents
INTRODUCTION
Digital-to-Analog Conversion (ADA1200 Only)...........
..........................t-3
What Comes With Your
Applications Software and Toolkit
............i4
CHAPTER 1 - BOARD SBTTINGS
Factory-Configured
Switch and Jumper Settings
...............1-3
P3 - Analog Input Voltage Range (Facrory Setring: t0 Volrs)......
....................... 14
P4 - Analog Input Voltage Polarity (Facory Seuing: +/-) ..............
.....................14
P5 - DMA Request Channel (Factory Setting: Disabled).....
........... 14
P6 - DMA Acknowledge Channel (Factory Sening: Disabled)
......14
P7 -8254 Timer/Counrer Clock Sources @acory Serings: CLKI-XTAL, CLK2-OT1, pCK) ...................1-5
P8 - Intemrpt Source and Channel (Factory Setting: Jumpers on OT2 & G; Inremrpt Chs Disabled) ......... l-6
P9 - DAC I Output Voltage Range (Facory Seuing: +5 to -5 volts) ..........
.........1_7
P10 - DAC 2 Output Volrage Range (Factory Sening: +5 o -5 volts)............
......1_g
Pl I - A/D Data Word Bit State Set (Facory Setting: +/-) .............
..................... l_g
Plz - A/D Converter Status,/External
Gate 2 Monitor @actory Setting: EOC (A/D Converter Status)) ....... l-9
Sl - Base Address (Facory Setting: 300 hex (268 decimal) .................
..............1_9
Pull-up/Pull-down Resistors on Digital I/O Lines.....
.......1_10
CHAPTER 2 _ BOARD INSTALLATION
Connecting the Analog Input Pins
............24
Connecting the Trigger In and Trigger Out pins, Cascading 8oards.........
..............24
Connecting the Analog Outpurs (ADAI200 Only)...........
..................2-s
Connecting the Timer/Counters and Digital VO ...............
..................2_5
Running the 1200DIAG Diagnostics Prrogram
...................2_s
CHAPTER 3 -
HARDWARE DESCRIPTION ...........
.............3-1
D/A Converte
Di$tal I/O, Programmable Peripheral Interface
.................3_5
i-l
2-l