Storing; Maintenance; Daily Maintenance - Kemppi Minarc 150 Operating Manual

arc is lit move the electrode slowly forwards tilting it to appr. 10-15° pulling
angle. If necessary, adjust current value.
Shielding gas is used in DC TIG welding. Your dealer will give you advice on
choosing gas and equipment. Open the gas valve on the TTM 15V TIG torch.
When gas starts to flow, arc is lit by lightly scratching work piece with the tip
of the tungsten electrode. When arc is lit, its length is regulated by holding
the tip of the tungsten electrode at a suitable distance from the work piece.
Move the torch forwards from the starting point, usually in appr. 10-15°
pushing angle forwards. If necessary, regulate current rate. Stop welding by
lifting the torch off the welding piece and by closing the gas valve on the
torch.
NOTE! Always fix the gas cylinder so that it stays steadily in upright position
either in specially made wall rack or cylinder trolley. Always close the cylinder
valve after having finished welding.
3.5

stOring

Store the unit in a clean and dry place. Shield it from rain, and in
temperatures exceeding +25 °C from direct exposure to sun.
4.

MaintenanCe

NOTE! Be careful when handling electrical cables!
In maintaining the unit, take into consideration the rate of use and the
environment it is used in. When the unit is used properly and serviced
regularly, you will avoid unnecessary disturbances in use and production.
4.1

Daily MaintenanCe

Perform the following maintenance daily:
• Clean electrode holder and TIG torch's gas nozzle. Replace damaged or
worn parts.
• Check TIG torch's electrode. Replace or sharpen, if necessary.
• Check tightness of welding and earth cables connections.
• Check condition of mains and welding cables and replace damaged
cables.
• See that there is enough space in front of and back of the unit for
ventilation.
EN
13