Table of Contents
Advertisement
Changing Satellites - DAC-2202 Ver 6.08g With a 9711 TXRX Antenna System
Basic button pushing in any one of the sub-menus is; Use the LEFT and RIGHT arrow keys to bring up, and move, the cursor
to select a character. Use the UP or DOWN arrow keys to increment or decrement the selected character to the desired value.
Status
SEA TEL INC – REMOTE
9711 VER 2.03
Ship Menu
LAT 38 N
LON 122 W
Verify that LAT, LON & HDG are correct.
HDG 000.0 000.0
Press NEXT 2 times
Antenna Menu
AZ
123.4
EL 056.7
REL 234.5
AGC 1234
Press ENTER 5 times
REFLECT A
AGC 1234
Brings up the cursor.
Toggle Reflector selection:
Assure that Reflector A for C-Band is selected.
Press NEXT 2 times
Status
SEA TEL INC – REMOTE
9711 VER 2.03
CONTROL
TRACKING
On
Lin P
Brings up the cursor.
Toggle through the list of possible BAND selections:
Press and Hold the Left & Right arrows
until "AUTO TRIM" is displayed
Quick Press and release the Left & Right
arrows until "SAVE NEW PARAMETERS"
Press UP arrow 3 times
Set to desired Transmit polarity. Select:
1 for LHCP TX
SETUP
2 for Horizontal TX
TX Polarity
0002
3 for RHCP TX
4 for Vertical TX
Press NEXT 2 times
Satellite Menu
SAT 101 W
THRS 1234
MHZ 1100
NID
1234
Press ENTER 3 times
MHZ 1100
AGC 1234
Set to the desired MHz frequency that you want to use for
Tracking.
Press ENTER 2 times
KHz 250
AGC 1234
Set to the desired KHz frequency that you want to use for
Tracking.
Press ENTER 4 times
Skew 0000
AGC 1234
Set to the known Polarization skew (in whole degrees) for
the satellite currently being, or intended to be, tracked.
Values less than 0000 will be displayed as a negative
value.
Press ENTER 3 times
SAT 180.0 W
Set to the desired Satellite Longitude and Hemisphere.
The desired satellite is
now being targeted.
is displayed
Advertisement
Table of Contents
Troubleshooting
