Selecting Air Pressure Units Of Measure; Control/Display Board Assembly - ESAB Powercut 900 Instruction Manual

SECTION 7
7.4

Selecting Air pressure Units of Measure

1. Set SW1-1 dip switch for desired air pressure units of measure.
• PSI - "OPEN"
• BAR - Not Open
2. SW1-2 is not used.
3. Verify SW2 - 1,2 dip switches are in the "open" position for proper operation.
7.5

Control/Display Board Assembly

NOTE: Requires software version 1.05 or higher (displayed during power-up). Refer to Section 4,
Subsection 4.1.E1. Contact factory for any required software updates.
CONTrOL/DISpLAY BOArD ASSEMBLY
P/N 0558038317
BAR
67
rEpLACEMENT pArTS
SW2-1,2
SW1-1,2
PSI