Secondary Output Connections Mechanized Cutting; Torch Installation - ESAB Powercut 900 Instruction Manual

SECTION 3
3.8

Secondary Output Connections Mechanized Cutting

Torch Cable
Clamp the work cable to
the workpiece.
WArNINg
3.9 pT-37 Torch Installation
1. Open torch lead access door on the front panel of the Powercut 900.
PT-37 Torch
Be sure the workpiece is connected to an approved
earth ground with a properly sized ground cable.
figure 3-5. powercut Interconnection Diagram
MAKE SUrE pOWEr SWITCH ON CONSOLE IS IN Off pOSITION AND
prIMArY INpUT pOWEr IS DE-ENErgIZED.
Torch Lead
Access
Door
51
INSTALLATION
SAFETY GROUND