SECTION 3
3.7
Secondary Output Connections for Manual Cutting
WORK
SAFETY
GROUND
WArNINg
3.8
pT-38 Torch Installation
1. Open torch lead access door on the front panel of the Powercut 900.
figure 3-4. powercut Interconnection Diagram
MAKE SUrE pOWEr SWITCH ON CONSOLE IS IN Off pOSITION AND
prIMArY INpUT pOWEr IS DE-ENErgIZED.
Torch Lead
Access
Door
The PT-38 torch comes factory installed with the
manual packages.
Clamp the work cable to the workpiece. Be sure
the workpiece is connected to an approved earth
ground with a properly sized ground cable.
PT-38 Cutting Torch
28
INSTALLATION