Hangar 9 Cessna 182 Skylane Instruction Manual page 14

Section 3: Installing the Aileron Servos
Step 4: Next, take the string and tie the end to your servo
extension lead, which is also connected to the servo lead. Make
sure the connectors will not separate by temporarily using
masking tape to secure the connectors together. Now you can
feed the servo leads through the opening.
Step 5: Install the servo into the aileron servo slot.
Note: It does not matter which direction the servo is
installed into the slot; in other words, if the servo horn
is closer to the aileron. However, both wing servos
should be mounted the same way.
Step 6: Securely fasten the servo in the aileron slot with four of
the servo mounting screws supplied with your radio system.
14
Step 7: Follow Steps 1-5 for the other aileron servo.
Step 8: Plug both aileron servo connectors into a Y-harness
and feed the excess servo lead wire back into the wing.
CONTINUED