Hangar 9 Cessna 182 Skylane Instruction Manual page 16

Section 4: Installing the Aileron Linkage
Step 7: Install the clevis with the attached linkage to the aileron
control horn. Center the servo horn as shown and, using a felt
tipped pen, make a mark on the linkage where the Z-bend will be
inserted into the horn.
Step 8: Make a Z-bend in the linkage and cut off the excess
linkage.
16
Step 9: Center the standard size servo horn and install the
Z-bend into the outermost hole. Do the same for the other
aileron linkage.
Step 10: Attach the linkages onto their respective aileron horns.
Step 11: With the servo arm centered as shown, adjust the
aileron linkage until the aileron is exactly in the neutral position.
Follow this procedure for both aileron linkages. Final
adjustments will be made later as you adjust the control throws
in Section 19.
Note: It is a good idea to place a piece of fuel tubing over
the clevises as shown. This will provide extra
insurance against the clevises accidentally coming
open.
CONTINUED