Table of Contents
Advertisement
SAS-to-SATA II RAID Subsystem
Chapter 3 Configuration Utility Options
The subsystem has a setup configuration utility built in containing important information
about the configuration as well as settings for various optional functions in the
subsystem. This chapter explains how to use and make changes to the setup utility.
Configuration Methods
There are three methods of configuring the subsystem. You may configure through the
following methods:
• VT100 terminal connected through the controller's serial port
•
Front panel touch-control keypad
• Web browser-based Remote RAID management via the R-Link ethernet port
IMPORTANT! The subsystem allows you to access the utility using
only one method at a time. You cannot use more than one method
at the same time.
3.1 Configuring Through a Terminal
Configuring through a terminal will allow you to use the same configuration options and
functions that are available from the LCD panel. To start-up:
1.
Connect a VT100 compatible terminal or a PC operating in an equivalent terminal
emulation mode to the monitor port located at the rear of the subsystem.
NOTE: You may connect a terminal while the subsystem's power is on.
2.
Power-on the terminal.
3.
Run the VT100 program or an equivalent terminal program.
27
Installation and Configuration Manual
Advertisement
Table of Contents
