2.2 Preparing the Subsystem and Powering On
Here are the steps to prepare the RAID subsystem for use.
1. Attach network cable to the R-Link port and connect the other end of network
cable to your network hub/switch. Or as alternative for configuration, you may
connect the serial cable to the Monitor port and to the serial port of your
host/server.
2. Connect the SAS cable(s) to the SAS Host Channel(s) of the RAID subsystem and
to the SAS switch or SAS HBA on host/server.
3. Connect the power cord to the AC input socket. Plug the other end of power cord
to the power source.
4. Press on the Power Switch.
SAS-to-SATA II RAID Subsystem
Installation and Configuration Manual
26