Chapter 2 Getting Started; Installing Hard Drives - Sans Digital Mobileraid MR8X Detailed User's Manual

Chapter 2 Getting Started

This section describes the physical locations of the hard drives supported by the
subsystem and give instructions on installing a hard drive. The subsystem supports
hot-swapping allowing you to install or replace a hard drive while the subsystem is
running.
This also discusses on how to power-on the subsystem in preparation for operation.

2.1 Installing Hard Drives

a. Make sure the Lock Groove is in unlocked position. Press the button and the Drive
Carrier handle will flip open.
b. Pull out an empty disk tray. Pull the handle outwards to remove the carrier from the
enclosure.
SAS-to-SATA II RAID Subsystem
Carrier
Open
Button
Installation and Configuration Manual
24