Table of Contents
Advertisement
installation
|
34
Follow these instructions before the Initial installation into the framing.
If installing the optional fan into an Existing installation see the instruc-
tions on the following page.
120 Volt AC power is needed for the fan. The fan can be hard wired if de-
sired. The outlet should be installed in the receptacle box on the left hand
side by a qualifi ed electrician. The neutral (wider) slot of the polarized
outlet should be at the top.
Unit must be grounded at all times. Do not cut the ground terminal
off under any circumstances.
1. Remove lower base cover by tilting forward and lifting out each side to
release.
2. Loosen four (4) screws (two on each side) inside of the bottom panel of
the clean front, slide panel out.
3. Turn the fan base on its side (with base facing forward) and then slide
the fan in towards the rear of the unit. Turn the fan upright and slip it
over the two mounting studs. Take care not to damage the insulation on
the fan base.
Ensure the fan blades do not rub against the valve tubing.
4. Connect the power cord and fan ground wires to the ground lug. Refer
to wiring diagram
34 |
Regency HZ33CE-10 Gas Fireplace
919-423
OPTIONAL FAN INSTALLATION
OPTIONAL FAN INSTALLATION
1
5. Slide the thermodisc/cover assembly on to the bracket clip on the
underside of the fi rebox.
6. Install the Fan Control Module (FCM) on the base of the unit to the left
of the gas valve. Plug the FCM into the outlet.
7. Plug in the fan power cord to the Fan Control Module into the outlet
marked "Fan". Plug the FCM-COM wire from the remote control wiring
harness into the location on the Fan Control Module marked "COM".
Turn the switch on the Fan Control Module to the ON position. ON is to
the left. The "O" is the off position
TO REMOVE THE FAN
1) Turn the power off.
2) Reverse the above instructions
MAINTENANCE: The sealed bearings are lubricated so there is no need
to lubricate them further. Extra lubricant will cause more lint and dust to
build up causing the premature failure of the bearings.
Regular cleaning and vacuuming of the fan area will add to the life of the
motor
IMPORTANT:
THESE FANS COLLECT A LOT OF DUST FROM
WITHIN YOUR HOME. ENSURE YOU MAINTAIN THESE
FAN MOTORS ON A REGULAR BASIS BY VACUUMING
THE FAN BLADES AND THE HOUSING WITH A SOFT
BRUSH NOZZLE.
HZ33CE
Thermodisc Clip
08/14/14
Advertisement
Table of Contents
