KVH Industries TracPhone V3IP User Manual page 60

7. Connect all other (non-static IP) computers and/or network
devices to "User Ethernet" ports 1-3 on the rear panel of the
ICM. For example, you might wish to add an external WAP (or
Wi-Fi router configured for bridge mode) to supplement Wi-Fi
access. Use straight-through 100 Mbps fast Ethernet UTP CAT5
cables (or better) with RJ45 connectors.
8. To enable the ICM's built-in wireless access point (WAP) for
Wi-Fi access, follow the steps in
page 70.
9. Make sure all non-static IP computers are configured for
DHCP addressing (see
page 72). Devices connected to "User Ethernet" ports 1-3 and
Wi-Fi will receive IP addresses from the ICM via DHCP. The
ICM serves as a router.
NOTE: By default, the ICM has a gateway of 192.168.5.1 and assigns IP
addresses in the 192.168.5.100-200 range. If this configuration conflicts with
an existing onboard network, you may change the settings at the TracPhone
V3-IP web interface (go to Settings > Network Settings). See
on ICM" on page 78 for details.
"Wireless Settings" on
"Configuring Computers for DHCP" on
TracPhone V3-IP User's Guide
Network Configuration
"LAN Settings
59