KVH Industries TracPhone V3IP User Manual page 105

No. Description
123 Error: The ICM's built-in modem is not responding to
status queries. Contact KVH.
124 Warning: The software update file you selected is not valid
for the TracPhone V3-IP. Try a new update file.
127 Error: The antenna is not accepting the no-transmit zones
setup from the ICM. Contact KVH.
128 Warning: The software update failed. Retry updating the
software. If it fails again, check the power/data cable and
the wires on the back of the ICM.
200 Warning: The antenna is not receiving adequate DC power
from the ICM. Check the power/data cable and the wires
on the back of the ICM.
204 Error: The antenna's main board has lost RF
communications. Try updating the software (see
Updates" on page
206 Error: The antenna's azimuth motor or limit switch failed.
Contact KVH.
208 Error: The antenna's elevation motor or limit switch failed.
Contact KVH.
218 Error: The antenna's skew motor or limit switch failed.
Contact KVH.
219 Error: One of the antenna's gyros is out of calibration. Try
recalibrating the gyros (see
page 142). If a gyro fails to calibrate, contact KVH.
220 Warning: One of the antenna's gyros failed. Contact KVH.
221 Error: The system is not receiving any GPS data. Contact
KVH.
222 Warning: The antenna's internal temperature exceeds
acceptable limits. Turn off the system and allow it to cool. If
the problem persists, contact KVH.
234 Error: The antenna is not receiving satellite signal strength
(RSSI) data from the ICM. Try these steps:
• Turn the ICM off, then back on.
• Check the wires on the back of the ICM.
• Check the power/data cable.
TracPhone V3-IP User's Guide
131).
"Gyro Calibration" on
Troubleshooting
"Software
107