Table of Contents
Advertisement
Connection Details/Dimensions - 240 model
560
70
130
210
490
520
Connection Details/Dimensions - 260 model
610
50
130
240
510
550
Connection Details/Dimensions
Diagrams opposite show the connection details
and dimensions for the BoilerMate A-Class SP
SOL appliance.
The BoilerMate A-Class SP SOL units are supplied
on an installation base to allow the pipe runs
to connect to the appliance from any direction.
It is easier if all pipes protrude vertically in the
cut out area shown. Compression or push fit
connections can be used. All pipe positions
are approximate and subject to a tolerance of
+/-20mm in any direction. A 15mm cold water
supply and a 22mm warning/overflow pipe
may also be required for the separate feed and
expansion cisterns if these are located in the
appliance cupboard.
Note: All dimensions are shown in mm and
are to the centre line of pipework/gland.
Figure 1.5
Figure 1.6
Page 7
DESIGN
Advertisement
Table of Contents
