Table of Contents
Advertisement
12/03 Rev. 3.00-01
Upgrading
Supplementary devices
SERVICE MANUAL
Printer versions
The TTX 350/OCELOT can be supplied in six different versions:
Resolution
8.0 dot
11.8 dot
X
X
X
X
X
X
In order to operate the TTX350/OCELOT with supplementary devices such
as cutters, stackers or rewinders, a so-called periphery set-up is necessary,
i.e. an additional printed circuit board – the peripheral board – which
controls the drive and sensors of the supplementary device is built in.
Upgrading between the six printer versions at a later date is possible. Here,
the following three cases are possible:
-- Upgrade from 8.0-dot to 11.8-dot resolution
-- Subsequent set-up for supplementary devices (periphery set-up)
-- Subsequent installation of the dispenser
TTX 350
Periphery set-up
X
X
X
X
21
General Service
Dispenser
X
X
Advertisement
Table of Contents
