Draytek Vigor2860 series User Manual page 667

> ip aux ?%% ip aux add [IP] [Join to NAT Pool]
%% ip aux remove [Index]
%%
%%
%%
Now auxiliary WAN1 IP Address table:
Index no.
----------------------------------------------------
1
2
When you type ip aux?, the current auxiliary WAN IP Address table will be shown as the
following:
Index no.
----------------------------------------------
1
2
3
T T e e l l n n e e t t C C o o m m m m
This command allows users to set/add a specified LAN IP your router.
S y n t a x
S y n t a x
ip addr [IP address]
S y n t a x
S y n t a x
Parameter
IP address
E E x x a a m m p p l
>ip addr 192.168.50.1
% Set IP address OK !!!
Info
Vigor2860 Series User's Guide
Where IP = Auxiliary WAN IP Address.
Join to NAT Pool = 0 or 1.
Index = The Index number of table.
Status IP address
Disable 0.0.0.0 Yes
Enable 192.168.1.65
Status IP address
Enable 172.16.3.229
Enable 172.16.3.56
Enable 172.16.3.113
a a n n d d : : i i p p a a d d d d r r
D e s c r i p t i o n
D e s c r i p t i o n
l e e
When the LAN IP address is changed, the start IP address of DHCP server are
still the same. To make the IP assignment of the DHCP server being
consistent with this new IP address (they should be in the same network
segment), the IP address of the PC must be fixed with the same LAN IP
address (network segment) set by this command for accessing into the web
user interface of the router. Later, modify the start addresses for the DHCP
server.
NAT IP pool
Yes
IP pool
Yes
No
No
Description
It means the LAN IP address.
653