Touch Controller Board - HP ELITE x2 1012 G1 Maintenance And Service Manual

Touch controller board

IMPORTANT:
and replacement.
Description
Touch controller board
Before removing the touch controller board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Keyboard (select products only) (see
b. Back cover (see
c. Display panel (see
Remove the touch controller board:
▲ Remove the 2 Phillips screws (1), and then remove the touch controller board (2).
Reverse this procedure to replace the touch controller board.
Make special note of each screw and screw lock size and location during removal
Back cover on page
Display panel on page
Keyboard (select products only) on page
30)
31)
Component replacement procedures
Spare part number
844861-001
29)
33