Table of Contents
Advertisement
6-4-4. Black Mark Sensor Alignment Mode
1.
Turn the printer off and unplug the power cord.
2.
Place the printer upright as shown below to remove the screws and remove the dip switch
cover from the bottom of the printer. Be sure to place the printer upright because you will
not be able to properly adjust the printer if it is placed on its side.
CAUTION
The printer will be unstable and could fall when it is placed upright. Therefore, secure the printer
by placing your hand on the printer before performing this operation.
Power OFF
3.
Since it is adjusted by rotating the volume VR2, check the position of the volume. Prepare
a small slotted screwdriver that will fit in the hole.
4.
Set the roll paper not for black mark.
5.
Enter the black mark sensor adjustment mode according to the procedure described Section
6-4.
6.
Rotate the volume VR2 using micro screwdriver, to adjust it to a position whereat both the
ERROR (red LED) and the POWER (green LED) lamps light.
7.
Turn the power OFF.
This completes the black mark sensor adjustment.
– 30 –
Advertisement
Table of Contents
