Star SP712R series Hardware Manual page 21

4 Push 3 to 4 cm of the leading edge of the bottom
sheet through the slit in the spool.
5 Bend the paper roll towards you, over the slit.
6 Wind the paper roll twice around the spool.
Note: Wind the paper roll without loosening it,
while the right end of the paper roll is in
contact with the spool rim.
7 As you load the spool onto the paper rewinder
frame, press the center of the paper roll with your
finger so that it would not unravel from the spool.
3 to 4 cm
– 17 –