Table of Contents
Advertisement
4-2-4. Connecting Ethernet Cable
If a ferrite core is included, install the ferrite core onto the Ethernet cable according to the fol-
lowing procedure to prevent electrical noise.
If a ferrite core is not included, perform steps (1) and (5) only.
(1) Make sure the printer is turned off.
(2) Affix the ferrite core onto the ethernet cable as
shown in the illustration below.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it.
Use scissors to cut off any excess.
Ferrite core
(5) Connect the interface cable to the connector on
the rear panel of the printer.
Ethernet Interface Board
IFBD-HE06
Link disconnection detection feature
The Ethernet interface model is equipped with a link
disconnection detection feature. If the printer is turned
on when an Ethernet cable is not connected to it, the
POWER and ERROR lamps are simultaneously turned
on and off at 2-second intervals to indicate the discon
nection.
Be sure to connect the Ethernet cable from a PC or hub
to the printer, and then turn the printer on.
Ethernet cable
Fastener
1 cm
(maximum)
Ethernet Interface Board
IFBD-HE08
– 9 –
Advertisement
Table of Contents
