Home Theater Processor Connection; Subwoofer Connection - Luxman C-1000f Owner's Manual

Connections

SUBWOOFER CONNECTION

Quite often there are two ways to connect one or two subwoofer(s) to one's system.
Speaker output (High Level) or Line Level.
Speaker (High Level) Connection
Simply connect a speaker cable either to the Speaker Terminals and then to the Speaker terminal
INPUT on the Subwoofer. Or alternatively connect an additional speaker cable to the speaker's
binding post and the other end to the Subwoofer's Speaker terminal INPUT.
Please ensure that you do not invert the phase by mixing the Left and Right Channel connections.
Best to run one cable at a time and connect Left to Left at each end, then repeat the process for
the Right channel.
Preamplifier (Line Level) Connection
1. Connect the L female RCA (white) end of your interconnect cable to the C-600f's L OUTPUT
and connect the other end to the L INPUT on your subwoofer.
2. Ditto for the R channel (red), repeat as above.
HOME THEATER PROCESSOR
In the situation where you would like your C-1000f to drive the front Left and Right speakers of your
Home Theater audio system and still be able to enjoy stereo CDs & LPs played through the C-
1000f.
1. Connect an RCA cable from the Output of you HT Processor, this will connect to the input that
you assign of the C-1000f.
2. Select the assigned input on your Luxman control amplifier from the Input Selector
3. Set the volume control to -21 dB. (Actual Unity Gain is -11 dB)
4. Now calibrate the output volume of your Home Theater Processor to have an
equal amplitude measurement from all your multi-channel speakers as measured at
the central listening position.
5. When you are finished with the Home Theater and want to listen to music again, simply turn
the volume back down to -50 dB and change inputs.
6. You should acquire the habit of lowering the volume, when changing between inputs or before
playing a record.
1
9