Wiring Connection - Luxman M-03 Owner's Manual

(-) to (-), as the incorrect connections would result
in improper phase and subdued low frequency
response. Follow the steps above for connection of
your second 2-speaker system, but this time to the
"SPEAKERS B" terminals.
Wiring Connection
1. Cut away about 15mm of insulating shield from the
end of speaker cables and twist the exposed loose
wires.
j
l5mm
r-
<>
~-o
Prepare speaker cable end as shown.
2. Rotate the knob on the SPEAKERS terminals coun-
terclockwise. Insert the twisted bare portion of the
speaker wire into the opening inside. Secure the
wire by rotating the knob clockwise until it is tight.
3. When connecting the speaker terminals, be sure no
bare portion or stray strands of wire touch a sec-
ond terminal or the chassis - a harmful short could
result.
4. Press the A or B (or both) SPEAKERS select
switches to activate the speakers.
h
A B
n
~
A, (BTL)
ON OFF
B OFF
ON
A and B ON
ON
5. Set the SPeaker IMPEDANCE/Ohm switch to the
correct position.
SP I MPEDANCE/Q
8 6 4
Speaker Impedance
6. Set the INDICATOR PEAK HOLD TIME/SEC switch
to the position where you get the easy reading on
the PEAK POWER LEVEL INDICATOR/WATTS.
I NDICATOR PEAK HOLD TIME/SEC
OFF 3
Peak Hold Time
7. ATTENUATOR Operation
Normally, set the A TTENUATORs on the M-03 at
the MAX position and adjust the volume control on
your pre-amplifier for your desired sound level.
Adjust the A TTENUATORs only when the input sig-
nal level is too high or not balanced between the
channels. Adjust the left and right input sensitivity
with the LEFT and RIGHT ATTENUATORs.
8
, gd
et