The exclamation point within an equi- The lightning flash with arrowhead, lateral triangle is intended to alert the within an equilateral triangle, is intended user to the presence of important to alert the user to the presence of uninsulated “dangerous voltage” within operating and maintenance (servic- the product’s enclosure that may be of ing) instructions in the literature ac-...
Thank You Your decision to purchase this Luxman C-600f Control Amplifier singles you out as one of the most discriminating music listeners. Luxman have been hand-crafting exquisite audio reproducing equipment in Japan since 1925. Luxman’s relentless dedication to Quality is your assurance that you will receive many years of musical enjoyment from this unit.
Front Panel Controls STAND-BY INDICATOR, glows yellow while in stand-by. POWER STAND-BY / ON, push button turns the C-600f either ON or OFF (stand-by). POWER INDICATOR; LED blinks gently initially to show that it is warming up, will shine constantly once the C-600f is fully operational.
Page 6
Front Panel Controls VOLUME DISPLAY, the illuminated display makes it easy to view the gain setting even from a distance. OUTPUT MODE cycles between modes: UNBAL BOTH UNBAL OUTPUT MODE – Unbal. The blue LED shows that the unbalanced output is active. OUTPUT MODE –...
LINE PHASE SENSOR. Here is a clever device found on the back of almost every Luxman powered product. You press the button and it will check the phase of the electricity it is receiving.
Page 8
Rear Panel Controls MAIN POWER Switch. If you are not using your C-600f for an extended period of time and want to turn off the power completely. The remote control will not be able to activate the control amplifier. REMOTE TRIGGER. Generates a 12 volt DC trigger signal which will activate a LUXMAN B-1000f, M-800A or M-600A.
Page 10
Rem ote Control Operation (On / Stand-by) push button turns the L-550A either ON or OFF (stand-by). The muting circuit operates for about 60 seconds after the power is turned on, until the circuitry stabilizes. No sound is heard during this period. While the unit is warming up, you will see the legend: WARMIN G UP Input Selection...
Page 11
Rem ote Control It is motor driven and can be adjusted from the remote control handset. The VOLUME control does not affect recordings made using the Tape output (REC OUT) but will affect the signal going to the Pre-amplifier output (Pre Out). IN : BAL.
Using the buttons, you can now toggle between +3 , -2 or -3 , 2+ iv. In the USA, most balanced products use Pin 2+. While Luxman use Pin 3 +. Press PRESET to exit. The two balanced inputs can be set individually.
Tape outputs but will affect the signal going to the Pre-amp output (Pre Out). The C-600f is probably the only high-end preamp currently in the market to offer tone controls adjustable from the listening position, via the remote control – ideal for listening to stunning performances such as Carlos Kleiber’s performance of the Brahms Fourth...
Rem ote Control THE REMOTE CONTROL’S RANGE is approximately 16’ or 5 meters, within a 30 degree window. NOTE: Direct sunlight or very bright ambient lighting may affect the operating range and angle for the remote control handset BATTERY REPLACEMENT. The battery well is easily accessed by sliding back the lower rear cover.
Installation The C-600f can be placed upright on a table or shelf, standing on its four feet. It also can be custom installed in piece of furniture or cabinet of your choice. Always provide adequate ventilation for your C-600f. Cool operation ensures the longest possible operating life for any electronic instrument.
Page 19
E-1, E, 200 or EQ-88 + MT-88 + OPEQ-88), then connect the output of the phono stage to an input on the C-600f. If you hear a lot of hum, you will most likely need to run a copper cable between the record player’s chassis to the phono stage and possibly to the SIGNAL GROUND...
HOME THEATER PROCESSOR In the situation where you would like your C-600f to drive the front Left and Right speakers of your Home Theater audio system and still be able to enjoy stereo CDs & LPs played through the C-600f.
Luxman or an authorized Luxman repair center. The product must be packed and returned to Luxman or an authorized Luxman repair center by the customer at his or her sole expense. Luxman will pay return freight of its choice. A RETURNED PRODUCT MUST BE ACCOMPANIED BY A WRITTEN DESCRIPTION OF THE DEFECT AND A PHOTOCOPY OF THE ORIGINAL PURCHASE RECEIPT.
Page 26
After the first year, demo equipment needing warranty service must be packed and returned to Luxman Service Center by the dealer at his sole expense. Luxman will pay return freight of its choice. A returned product must be accompanied by a written description of the defect on an LUXMAN RETURNED GOODS AUTHORIZATION form.