Table of Contents
Advertisement
Installation
Instructions
INSTALLATION-VENTEDTO THE OUTSIDE
_-_ MOUNT THE HOOD
WARNING: 2people
are required to lift and
position the hood onto the mounting
bracket.
AVERTISSEIENT
:
If faut deux personnes
pour lever et mettre en place
la hotte sur le support de montage.
, Lift the hood onto the mounting
bracket.
, Position a spirit level at the bottom of the hood to
check side to side leveling.
[6] LEVEL THE HOOD
This hood has built-in levelers on the mounting hooks
at each side. Use a long Phillips screwdriver from the
front to access the levelers.
, Use the top screw hole in the leveler to raise or lower
the hood on that side.
, Use the bottom screw hole to pull the hood tight
against the wall surface.
Screw hole
, Mark hole location at the bottom of the hood.
, Remove the hood. If the bottom screw hole does not
enter a stud, enlarge the hole to 3/8% and install wall
fastener anchors.
, Place the hood back onto the mounting bracket,
check level again and install the wall fastener.
[-_
CONNECT DUCTWORK
, Install ductwork,
making connections
in the
direction
of airflow as illustrated.
, Push duct over the exhaust outlet and damper.
, Secure joints in ductwork
with sheetmetal
screws.
, Wrap oil duct joints and the flange connections
with duct tope for on airtight
seal.
Ai rfl ow
Duct tape
-_t--
over seam
and screw
--
Sc rew
CAUTION:
Do not use sheet metal screws
at the hood flange connection.
Doing so will prevent
proper damper operation.
Seal connection
with
tope onlg.
PRUDENCE:
II ne fout pos utiliser de vis autorourdeuses
(_ Io
connexion
du collet de la hotte. Ceci emp6cheroit
le ban fonctionnement
du registre. N'utiliser que du
ruban adh6sif pour assurer 1'6tanch6it6 du raccord.
12
Advertisement
Table of Contents
