Installing The Int-P9 Controller Onto The Wheelchair; Repositioning The Controller Mounting Tube - Invacare POWER 9000 Owner's Operator And Maintenance Manual

INSTALLING THE INT-P9 CONTROLLER
ONTO THE WHEELCHAIR (FIGURE 1)
NOTE: The controller mounting tube is factory set
for installation onto the right side of the wheel-
chair. To reposition controller mounting tube for
installation onto the left side of the wheelchair,
refer to REPOSITIONING THE CONTROLLER
MOUNTING TUBE in FIGURE 2 of this instruction
sheet.
1. Position the threaded hole half clamp and
opened hole half clamp on the arm tube. Make
sure the threaded hole half clamp is on the in-
side of the arm tube.
2. While holding the two (2) half clamps, line up
the mounting holes of the controller mounting
bracket (bracket) with the open and threaded
holes of the half clamps and install the three (3)
socket screws.
3. Securely tighten the three (3) socket screws that
fasten the bracket to the two (2) half clamps.
4. Slide the controller mounting tube (tube) through
the bracket to the desired position.
5. Slide the adjustment lock over the end of the
tube and secure the adjustment lock to the tube
by turning the lever on the adjustment lock.
Arm Tube
(reference only)
Threaded
Hole Half
Clamp
Opened Hole
Half Clamp
Controller
Mounting
Adjustment
Bracket
Lock
FIGURE 1 - INSTALLING INT-P9 CONTROLLER
ONTO THE WHEELCHAIR
Controller
Controller
Mounting
Tube
Left/Right
Motor
Leads
Socket
Battery
Screws
Lead
6. Connect the controller left/right motor and bat-
tery leads to the motors and batteries.
REPOSITIONING THE CONTROLLER
MOUNTING TUBE (FIGURE 2)
1. Disconnect the left/right motor leads and bat-
tery leads.
2. Turn the lever on the adjustment lock and re-
move the controller from the mounting bracket.
3. Remove the ACTION LOGO on the right side of
the controller.
4. Remove the two (2) socket screws and washers
that secure the controller to the tube.
Controller
Socket
Mounting
Screws
Opened Hole
Half Clamp
Adjustment
Lock
Socket
Screws
New ACTION
LOGO Label
Controller
Mounting
Bracket
Left/Right
Motor Leads
Battery Lead
Controller Mounting
FIGURE 2 - REPOSITIONING THE
CONTROLLER MOUNTING TUBE
20
Arm Tube
Bracket
Threaded
Hole Half
Clamp
Washers
Controller
ACTION
LOGO Label
Washers
Socket
Screws
Repositioned
Tube