Replacing The Remote Control Battery - SMART Board M600ix3 Configuration And User's Manual

CHAPTER 3
USING THE INTERACTIVE WHITEBOARD SYSTEM

Replacing the remote control battery

Follow this procedure to replace the remote control battery.
WARNING
Reduce the risk associated with a leaking battery in the projector's remote control by
l
following these practices:
Use only the specified CR2025 coin-cell battery.
o
Remove the battery when the remote control is unused for an extended period.
o
Do not heat, disassemble, short or recharge the battery, or expose it to fire or high
o
temperatures.
Avoid eye and skin contact with the battery if it has a leak.
o
Dispose of the exhausted battery and product components in accordance with applicable
l
regulations.
To replace the remote control battery
1. Hold down the side release on the left side of the battery holder and pull the battery holder
completely out of the remote control.
2. Remove the old battery from the battery holder and replace it with a CR2025 coin-cell
battery.
IMPORTANT
Align the battery's positive (+) and negative (–) terminals with the correct signs on the
battery holder.
3. Insert the battery holder into the remote control.
10 smarttech.com/kb/170910