CHAPTER 4
MAINTAINING THE INTERACTIVE WHITEBOARD SYSTEM
Do not spray cleaners, solvents or compressed air directly on the projector. Do not use
l
spray cleaners or solvents near any part of the projector because they can damage or stain
the unit. Spraying the system could spread a chemical mist on some of the projector's
components and lamp, resulting in damage and poor image quality.
Do not allow liquids or commercial solvents of any kind to flow into the projector base or
l
head.
If wiping the mirror cover is unavoidable, wear protective gloves and gather the cleaning
l
cloth into a ball. Gently run the cleaning cloth across the lens mirror from the center to the
edge, using the cleaning cloth as you would a feather duster. Don't apply pressure to the
mirror cover.
IMPORTANT
When cleaning the interactive whiteboard system:
l
Wipe the exterior of the projector with a lint-free cloth.
o
If necessary, use a soft cloth moistened with a mild detergent to clean the projector
o
housing.
Do not use abrasive cleaners, waxes or solvents.
l
Focusing and adjusting the projector image
For information on focusing and adjusting the projector image, see Focusing the image on
page 22 and Adjusting the image on page 23.
Replacing the projector lamp
This section provides instructions for replacing the projector lamp module.
Removing and replacing the projector lamp module
Eventually the lamp will dim and a message will appear reminding you to replace the lamp. Make
sure you have a replacement lamp module before you proceed with the following instructions.
29
smarttech.com/kb/170910