Installing To Dimm1 Slot (Secondary) - Nexcom NDiS M324 User Manual

Chapter 3: System Setup
4. Insert the module into the socket at an approximately 30 degrees angle.
Apply firm even pressure to each end of the module until it slips down
into the socket. The contact fingers on the edge of the module will
almost completely disappear inside the socket.
The ejector tabs at the ends of the socket will automatically snap into
the locked position to hold the module in place.
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.

Installing to DIMM1 Slot (Secondary)

1. Follow the instructions in the "Removing the Chassis Cover" section to
remove the top cover.
23
NDiS M324 User Manual