Operation; Oled Display; Turning On & Standby; Volume Adjustment - Roksan Audio Attessa Owner's Manual

Operation

OLED Display

ATTESSA INTEGRATED AMP
To preserve the life of the OLED display, there is an automatic display saver mode.
If there are no commands received for 2 minutes the display will turn off until a command is received.
Turning On & Standby
A single press of the standby button on the unit or single press of the standby button on the remote will
wake the unit from standby and the button LED will turn solid orange. The Roksan logo will also appear on
the display to the left of the Volume/ Input Selection Knob followed by the A2 Input (when used for the first
time or when the power is removed) or the last used input if woken from standby.
A single press of the Standby Button on the unit or single press of the Standby Button on the remote and
logo will turn solid red and the display will go off and the unit will enter standby mode.

Volume Adjustment

Volume adjustment is achieved by either rotating the Volume/ Input Selection Knob (clockwise to increase
the volume and anti-clockwise to decrease the volume) or by pressing the buttons on the remote. The
Volume LEDs will be illuminated on the right hand side of the Volume/ Input Selection Knob showing the
current volume.
The volume can be muted by turning the knob anti-clockwise or by pressing the Mute button on the remote
control. A momentary press of the encoder will also put it into mute and take it out of mute.
NOTE: If the unit is turned off with the volume above 75%, it will restart at a lower level to protect the
speakers and the Integrated Amplifier/ Streaming.
8 roksan.com