Operation - Roksan Audio blak Manual

blak Integrated Amplifier
Manual
LOUDSPEAKER CONNECTIONS
The right and left loudspeakers are connected to the amplifier via the rear panel binding
posts. Carefully observe polarity ensuring that the RED (+) speaker terminal is connected to
the RED (+) amplifier terminal and the BLACK (-) speaker terminal to the BLACK (-) amplifier
terminal. When both left and right channels are connected to the relevant speaker terminals
the amplifier is ready for use.
IMPORTANT NOTE:
For optimum performance it is recommended to use high quality inter-connect cables. Please
consult your dealer for advice.
For optimum performance it is recommended to use high quality speaker cable. Please
consult your dealer for advice. DO NOT use a speaker cable with conductor size less than 16
AWG (1.6mm Diameter). The binding posts accept conductor sizes up to 12 AWG.
HEADPHONE CONNECTION
To listen through headphones, connect a 6.35mm 1/4 inch Stereo Jack Plug to the
headphone socket (2).
SWITCHING ON
The mains power switch is located on the front left under side of the amplifier. This switch
should ON for normal operation and off when not in use. If unattended for a long period of
time (going on a short break, holidays etc.) the mains power should be switched OFF and the
power cord disconnected from the mains power input.

OPERATION

All specifications are liable to change without notice. E&OE
ROKSAN AUDIO
Monitor Audio Ltd, 24 Brook Road, Rayleigh, Essex, SS6 7XJ, United Kingdom
website: www.roksan.co.uk email: info@roksan.co.uk
Tel: +44 (0)1268 740580