Preparing The Machine - Bissell POWERWASH LIFT-OFF 1190 User Manual

PORTABLE SPOT CLEANING
MODE
C-6 Preparing the machine
1. Step on portable spot cleaning pedal to
release portable spot cleaner.
2. Release flex hose by twisting hose
secure latch clockwise. Unwrap flex hose
completely.
3. Attach desired cleaning tool to hose grip
until it snaps together. Make certain tool is
securely attached.
4. Twist Quick Release cable wrap clockwise
to unwrap power cable completely and plug
into grounded outlet.
C-7 Filling tank
Cleaning with Tools
Important! If using to clean upholstery,
check upholstery tags. Check manufac-
turer's tag before cleaning. "W" or "WS" on
tag means you can use your deep cleaner.
If tag is coded with an "X" or an "S" (with
a diagonal stripe through it), or says "Dry
Clean Only", do not proceed with any deep
cleaning machine. Do not use on velvet or
silk. If manufacturer's tag is missing or not
coded, check with your furniture dealer.")
1. Follow instructions for filling tank in
upright cleaning mode section in section
C-2.
2. Attach cleaning tool of choice to end of
hose.
3. Hold tool approximately 2.5 cm above
soiled surface. Press spray trigger to apply
cleaning solution to soiled area.
Caution: Do Not Overwet.
NOTE: Hold end of hose below tank
water level to help prime the portable
spot cleaner.
4. Using brush on tool, gently scrub the
area to be cleaned.
5. Apply downward pressure on tool and
pull it toward you. The suction will remove
dirt and cleaning solution. Continue until no
more dirt can be removed.
IMPORTANT
Check for colourfastness in an inconspicuous place. If possible,
check upholstery stuffing. Coloured stuffing may bleed through
fabric when it becomes wet.
Empty dirty tank
Follow instructions under Empty dirty tank
in section C-4.
C-8 Cleaning portable machine
1. Before turning off machine, suction up
clean water from a bowl or from tap to
rinse out interior of the hose. Then, lift the
cleaning tool and point it upwards to drain
any remaining water into tank.
2. Remove and rinse tools in clean, running
water. Dry and replace in tool storage
provided.
3. Coil flex hose around hose wrap and
secure with latch.
4. Check suction gate and if it appears dirty,
follow steps 1-4 under Cleaning Suction Gate
in section D-1.
C-9 Replacing portable machine
on base
1. Align machine as graphic shows, with
cable side on left and hose side on right.
2. Push down portable spot cleaner until it
can be heard clicking securely into place.
Test fit by pulling up on carry handle to
make sure it is secure.
www.BISSELL.com
9