Troubleshooting - Bissell POWERWASH LIFT-OFF 1190 User Manual

E

Troubleshooting

Problem Possible causes
Upright
Power is not turned ON
cleaning
mode
Portable spot cleaner is not
indicator light
attached completely
does not
illuminate
Formula & water tank may be empty
Formula & water tank may not be
seated completely
Reduced
spray or
Pump may have lost prime in
no spray
portable spot cleaning mode
Portable spot cleaner is not
attached completely
Portable spot cleaner is not
attached completely
Machine is in the upright position
DirtLifter™
Circuit breaker on machine
PowerBrush
(if equipped) may have tripped
does not turn
Belt is off or broken
Tanks may not be seated properly
Nozzle may not be assembled
properly
Loss of
Portable spot cleaner is not
suction
attached completely
power
Dirty tank has picked up
maximum amount of dirty water
and has reached full line
Formula & water tank is empty
Suction gate is open
Please do
not return
this product
to the store.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
To reduce the risk of electric shock, turn power
switch off and disconnect plug from electri-
cal outlet before performing maintenance or
troubleshooting checks.
Remedies
Power must be ON to activate indica-
tor light
Make sure portable spot cleaner is
attached. Push down firmly to check.
Refill tank
Turn power OFF. Remove and
reseat tank
Hold end of hose below water level
in tank to prime
Push down firmly to check connection
Make sure portable spot cleaner is
attached. Push down firmly to check
Brushes only rotate when machine is
reclined using recline pedal
Turn machine OFF and unplug from
outlet. Check to see if foreign object
is caught in brush roll. Remove object.
Plug machine in to reset circuit breaker
Turn power OFF and unplug unit
from outlet. Follow instructions in
sections D-3 and D-4
Pick up both tanks and reseat so they
fit snugly on the unit
Unplug machine and check to make
sure "lip" of nozzle is securely hooked
into groove on bottom of machine.
Follow instructions in section C-5
Make sure portable spot cleaner is
attached. Push down firmly to check
Empty dirty tank
Check fluid levels in formula & water tank
Check to make sure suction gate is
closed. Follow instructions in section D-1
www.BISSELL.com
11