Table of Contents
Advertisement
WEBVIEWER*
S E T U P > B A S I C C O N F I G U R AT I O N > N E T W O R K > T C P / I P
U s e t h i s m e n u o p t i o n t o s e t u p t h e c a m e r a ' s n e t w o r k s e t t i n g s .
Set the camera's IP address, subnet mask, gateway and DNS server information. If applicable, you can
also setup the camera for multicast.
• MAC Address: shows the camera's mac address.
• MTU: If applicable, you can enter the MTU setting value.
1500.
• Multicast Address: If you are using the Multicast protocol, you can enter a separate multicast address.
The Multicast sends a stream to the multicast group address and allows multiple clients to acquire the
stream at the same time by requesting a copy from the multicast group address. Before utilizing this
function, make sure the Multicast function is enabled on your router.
• Enable Multicast Discovery: Check the checkbox of Enable Multicast Discovery, and then the online
network camera can be automatically detected by client software via private multicast protocol in the
LAN.
• DNS Server – Enter a DNS address. The Domain Name Server translates a web addresses to an IP
addresses. You can enter up to two (2)
servers.
• Once all settings are adjusted, save all
changes. The camera will reboot to
apply the new network settings.
The valid value range of MTU is 1280 ~
2 6
Advertisement
Table of Contents
