Remote Control; Front Panel Controls; Input Selector; Volume - Pro-Ject Audio Systems MaiA Instructions For Use Manual

Remote control

ON/OFF
CH+
VOL+
VOL-
CH-

Front panel controls

To switch on from standby or to standby
The push button on the left side of the front panel turns the unit on or back into standby (press and hold to
switch into standby mode). The blue LED above the stand-by push button shows that the unit is switched on.

Input selector

After the unit is powered on, pressing the buttons
desired input.

Volume

Adjust the volume to the desired level, using the large knob on the front panel.

Connecting a headphone

Connect the headphones to the ¼" (6,3mm ) jack socket on the front of the unit.

Bluetooth connection

Make sure the antenna is attached to its connector In 9 BT on the back panel prior using bluetooth.
Bluetooth is active only once input 9 is selected.

Pairing with Android devices

Open Settings and tap on Bluetooth. Turn on Bluetooth and tap on Scan. Searched devices will show up.
Tap on "MaiA" (Enter "0000" if requested) and confirm by pressing power button on MaiA once the blue LED
of the input 9 is fast blinking. Once paired it will show "Connected to media Audio", now you can play music
from your Android device over Bluetooth to MaiA.
4
© Project Audio Systems · Pro-Ject MaiA · Revision 2014.7.8
1
ON/OFF
turns the unit on or back into standby
0 0
+
VOL VOL
and adjust the sound volume
0 0
+
CH CH
and select the inputs
◄ ►
and next to the LEDs inputs indicators selects