Connecting A Headphone; +6Db Button; Bluetooth® Connection; Pairing With Android Devices - Pro-Ject Audio Systems Stereo Box DS3 Instructions For Use Manual

Connecting a headphone

Connect the headphones to the ¼" (6,3mm ∅) jack socket on the front of the unit. Once headphone jack is
connected into the socket, rear panel outputs are muted.

+6dB button

gain of the preamplifier for all inputs is increased by 6dB if pressed
BLUETOOTH® connection
Make sure the antenna is attached to its connector In 5 BT on the back panel prior using BLUETOOTH®.
Only use the supplied antenna!
BLUETOOTH® is active only when input 5 is selected. If you want to connect your device the first time activate
the pairing mode by pressing and hold the button
visible & ready to pair for 60 seconds.

Pairing with Android devices

Open Settings and turn on BLUETOOTH®. Start a Scan for BLUETOOTH® devices. Searched devices will
show up. Tap on "Stereo Box DS3" and confirm presented pairing code on your Android device. When the
connection was successful, the LED of Input 8 lights up continuously. Now you can play music from your
Android device over BLUETOOTH® to Stereo Box DS3.
BLUETOOTH® pairing with Apple devices
Tap on Settings and turn on BLUETOOTH®. Your device will automatically start searching for available
devices. Tap on "Stereo Box DS3" and confirm the connection. When the connection was successful, the LED
of Input 5 lights up continuously.
BLUETOOTH® pairing with Windows smartphones
Open Settings and turn on BLUETOOTH®. A scan for available devices starts automatically. Searched devices
will show up. Tap on "Stereo Box DS3" and confirm presented pairing code on your Windows device. When
the connection was successful, the LED of Input 5 lights up continuously. Now you can play music from your
Windows device over BLUETOOTH® to Stereo Box DS3.
Stereo Box DS3 can store up to 8 BLUETOOTH® devices. If the memory is full, new connections will
automatically replace the oldest connection. A new connection is only possible if the LED of BT input is
blinking slowly (it indicates that no device is connected). You can reset & clear the BLUETOOTH®
module by holding the
will then turn on after the reset is completed.

Remote control

4
© Pro-Ject Audio Systems · Stereo Box DS3 · Revision 19.12.2022
►
(pair) until LED 5 starts blinking. The Stereo Box is now
◄
button and then turn the unit on. The LED 5 will quickly flash & the device
ON/OFF turns the unit on/off
VOL- turns the volume down
VOL+ turn the volume up
CH- select the input down
CH+ select the input up
MUTE activates and deactivates mute