Advertisement
Remote control
ON/OFF
CH+
VOL+
VOL-
CH-
Front panel controls
To switch on from standby or to standby
The push button on the left side of the front panel turns the unit on or back into standby. The blue LED above
the stand-by push button shows that the unit is switched on. Mute is active when LED is blinking.
Input selector
After the unit is powered on, pressing the buttons
desired input.
Volume
Adjust the volume to the desired level, using the large knob on the front panel.
Connecting a headphone
Connect the headphones to the ¼" (6,3mm ) jack socket on the front of the unit.
Bluetooth connection
Make sure the antenna is attached to its connector In 9 BT on the back panel prior using Bluetooth.
Bluetooth is active only once input 9 is selected. LED of Bluetooth input is blinking when no device is
connected. If the LED is on, active connection with Bluetooth device is established. Following procedures
refer to units from S/N E29069 and higher including previous units with implemented firmware update v1.3.
If you need a manual for units with previous serial numbers without firmware update, please contact your
local distributor.
Pairing with Android devices
Open Settings and tap on Bluetooth. Turn on Bluetooth and tap on Scan. Searched devices will show up.
Tap on "MaiA" and confirm presented pairing code on your Android device. Then press
MaiA (alternatively CH+ or VOL+ button on remote control) when the blue LED of input 9 starts blinking.
When paired with MaiA, your Android device will show "Connected to media Audio". Now you can play
music from your Android device over Bluetooth to MaiA.
4
© Pro-Ject Audio Systems · Pro-Ject MaiA, MaiA Pre · Revision 2014.10.8 (from S/N: E29069)
1
ON/OFF
turns the unit on or back into standby (long press), mute (short)
0
0
VOL
VOL
+
and
adjust the sound volume
0
0
+
CH
CH
and
select the inputs
VOL+ and CH+ confirm Bluetooth pairing
VOL- and CH- cancel Bluetooth pairing
◄
►
and
next to the LEDs inputs indicators selects
►
(pair) button on
Advertisement
