Installing Cables - Maxview Crank Up B2590/65 Installation & Operating Instructions Manual

Installing cables:

1. Check there are no hidden cables in the roof structure and that the hole location is clear of obstructions both
internally and externally.
2. See below for Cable Entry Cover instructions
Application example: Use extra Cable Entry Cover
to route 2nd Sat feed to a
different location.
Available to order from
Maxview MXL018
Direction of travel
(front of vehicle)
Note: To prevent trip hazards it is recommended that cables are concealed in PVCu conduit (not supplied)
where access is required to the roof of the vehicle.
Installing Cable Entry Cover:
1. Plan your installation
2. Drill hole in roof
3. Prepare surface for adhesion
4. Apply sealant as shown in A,B,C
(we recommend Sikaflex-512 Caravan)*
5. Position top hat
6. Position cable entry cover
7. Wipe excess sealant with a dry cloth
Applying sealant example:
A
!
C
Direction of travel
(front of vehicle)
Page 8
Hole location
tabs
B
!
!
32mm ø
= Generously apply
!
wet seal adhesive
Note: LNB
image shows
different
model.
Cable
Top hat