Table of Contents
Advertisement
Attach antenna unit to mounting plate:
Carefully lower the antenna unit onto the Mounting Plate and re-attach the M6 Nuts and Washers that
were previously removed.
Caution:
Replace Nylon locking nuts if they have been removed more than twice. The locking action of the Nylon
becomes less effective if repeatedly assembled and disassembled.
Installing cables:
1.
Check there are no hidden cables in the roof structure and that the hole location is clear of obstructions both
internally and externally.
2.
Turn over for Cable Entry Cover installation instructions
Application example:
Use extra Cable Entry Plate
to route 2nd Sat feed to a
different location.
Available to order from
Maxview MXL018
Direction of travel
(front of vehicle)
Note:
To prevent trip hazards it is recommended that cables are concealed in PVCu conduit (not supplied)
where access is required to the roof of the vehicle.
Visit: www.seekerwireless.co.uk for potential software updates
Page 9
Advertisement
Table of Contents
