Lowering Antenna - Maxview Crank Up B2590/65 Installation & Operating Instructions Manual

Lowering antenna:

Lock Azimuth Lock
1. Rotate the Dish Direction Unit until it aligns with
the Base Plate and Lock Azimuth (green).
2. Lower the antenna by rotating the Elevation
Handle anti-clockwise (approximately 25 turns
from 25 degrees until you see home position in
the window).
NOTE: The Home Position will go past the
Elevation window once during the lowering
operation before you see the Home Position for
the second time. This is normal operation.
Align Dish Direction
Pointer to Base plate
Antenna Down
3. Slowly turn the handle until elevation indicator
fully shows the home position and you feel
some park resistance. Do not over wind the
handle as this may damage the satellite system.
CAUTION: As a manual system we always
recommend the '3 point safety check'
Before travelling;
1. Elevation readout must show the Home
position (check park resistance felt)
2. Azimuth Lock Lever must be in the Green
Position and Park arrows aligned
3. Visual check on your roof to ensure the
Antenna is fully lowered.
Arrows align
for travel
Elevation
home
position
Page 15