Table of Contents
Advertisement
11.
Place a small amount of adhesive into each pilot hole before screwing plate to roof.
12.
Wipe off excess adhesive with a cloth.
Note:
> Follow manufacturer's instructions when applying adhesive. Do not travel until adhesive has cured noting
that curing times vary with weather conditions.
> Take care when working at heights. Always follow ladder manufacturer's safety advice.
> Use creeper boards where necessary to ensure roof construction can support your weight.
> Power tools should be used in accordance with manufacturer's instructions.
Attach Antenna Unit to Mounting Plate
Carefully lower the antenna unit onto the Mounting Plate and re-attach the M6 Nuts and Washers that were
previously removed.
Caution: Replace Nylon locking nuts if they have been removed more than twice. The locking action of the
Nylon becomes less effective if repeatedly assembled and disassembled.
7 x No. 10 screws (large)
Note:
DO NOT remove transit tape x 2
Note: LNB image shows different model.
Page 7
Hide quick links:
Advertisement
Table of Contents
