Table of Contents
Advertisement
5.
Place the Base Plate over the Coupler Bush. Point
the arrow to the rear of the vehicle. Mark the
four fixing holes. Drill four 2.5mm pilot holes or
use a bradawl. With four No.10 screws fix the
Base Plate to the ceiling.
Note:
Add the 2 x M5 washers as image below before
fixing the elevation handle
7.
Place the 4mm spindle into the elevation handle
and fix to the Dish Direction Unit with two M4
screws.
Rear of vehicle
Azimuth lock lever
Red = Unlocked
Green = Locked
(safe to travel)
6.
Take the Dish Direction Unit and turn the azimuth
lock lever to the red position to release the brake.
Locate the Dish Direction onto the Coupler Bush
and use three M4 screws fix it in place.
Align arrows
Page 11
Hide quick links:
Advertisement
Table of Contents
