Table of Contents
Advertisement
Installing Your Precision Waterways Mount
1. Locating your mount
1
90°
Roof
We strongly recommend mounting on the
centre line of your boat. For correct performance,
the nylon mount must be vertical.
2. Fixing in place
The mount plate is designed to be used on flat roofs or shallow curves. Always use at least 1 washer in each
corner, to allow clearance for plate fixings. If your roof has a more aggressive curve or cannot be mounted
centrally refer to section 2B.
Please Note: When installing with a flexible adhesive it is not necessary to use mechanical fixings, however do
not travel until adhesive has cured. Refer to adhesive manufacturers guidelines for curing times etc.
2A. Fixing to a flat roof
1
Mark out position of mount on roof and place at least
1 washer into each corner of marked out area.
Please Note: Washers must be used to allow
clearance for plate fixings
2
The mount should be in a location where a full
360° rotation can be achieved without any
obstruction.
2
We recommend using a flexible adhesive for all
installations.
a. See 'Tools Required' section for further details on
recommended sealants.
b. Clean roof in accordance with adhesive
manufacturers guidelines.
c. Apply Sealant under plate and a small
amount in each hole.
60cm
5
Advertisement
Table of Contents
