When Incorrect Copies Are Printed - Minolta DI2010 User Manual

9.2 When Incorrect Copies Are Printed

9.2 When Incorrect Copies Are Printed
Symptom
The printed output is too light.
The printed output is too dark.
The printed output is blurry.
Di2010/Di2510/Di3010/Di3510
Possible Cause
The "Auto" Density setting is
set too light.
A Density setting that is too
light is selected.
Many documents containing
photos or large printed areas
were printed.
The toner bottle was just
replaced.
The toner is empty and the
message "Please add toner."
appears in the touch panel.
The paper is damp.
The "Auto" Density setting is
set too dark.
A Density setting that is too
dark is selected.
The original glass is dirty.
The document was not pressed
close enough against the
original glass.
The paper is damp.
The document was not pressed
close enough against the
original glass.
Remedy
Adjust the "Default Copy
Output Levels" function on the
User's Choice screen.
Otherwise, cancel the "Auto"
Density setting, and then select
the desired setting.
Touch [Density], and then
select a darker Density setting.
The print density was dark and
reduced the toner supply.
Use the "Toner Replenisher"
function in the Utility mode to
replenish the toner.
The toner supply was reduced.
Use the "Toner Replenisher"
function in the Utility mode to
replenish the toner until the
copy density is darker.
Replace the toner bottle with a
new one.
Replace the paper.
Adjust the "Default Copy
Output Levels" function on the
User's Choice screen.
Otherwise, cancel the "Auto"
Density setting, and then select
the desired setting.
Touch [Density], and then
select a lighter Density setting.
Wipe the glass with a dry soft
cloth.
Position the document so that it
is pressed closely against the
original glass.
Replace the paper.
Position the document so that it
is pressed closely against the
original glass.
9
9-3