K-sun green machine User Manual page 84

• To cancel the process press
• A single label can have up to three bar codes and one sequence number or letter but bar
codes can not be sequenced.
• Bar codes contain considerable data, and use up a lot of memory when saved in files.
• To change the bar code number or the type of bar code, move the cursor to immediately
after (right side) the bar code mark "
menu will be displayed. Next, repeat the above process.
• To modify a bar code number, go to the bar code number enter screen, delete the
previously entered bar code number and enter the new bar code number.
• To delete a bar code, move the cursor to immediately after the bar code mark "
side) and press
• Style and Mode functions can be set for bar code marks in the same way as for standard
characters but will be shown as follows:
Settings that will be shown on bar code marks
Background, Length, Space, Frame & Table, Layout, Border & Line
• Always make sure that the bar codes are read correctly by a bar code reader before they
are used. If they are not read correctly by the bar code reader adjust the "Width" or
"Ratio" and check again.
• To print bar codes, it is recommended that you use a tape with a white background and
black characters as they are easily read by bar code readers.
• The digits that can be entered vary according to the type of bar code. ITF and CODABAR
allow 1 to 19.
• ITF bar codes only support even digit numbers. When entering even digit numbers with
Check Digit setting set to "On" or when inputting odd digit numbers with Check Digit
setting set to "Off", the spare code "0" is automatically input in the first row.
• The Check Digit of UPC-E is not displayed on the bar code number input screen or in the
bar code number.
• CODABAR cannot be read by the bar code reader unless one of "A, B, C, D" are input at
the beginning and the end of the code.
• The length of the bar code (bar area) and the length of the numbers is not always the
same. This does not affect their usability.
78
Additional Functions
or
key.
keys. This takes you back to the previous step.
" and press + keys . The "Bar code"
" (right