Scanning Computers - F4 - Minicom Supervisor Phantom Operating Manual

Scanning Computers – F4
You scan computers from the Select Computer window.
To start scanning:
Press F4. During scanning a Confirmation label appears, showing which Remote computer is presently
displayed. See Figure 2-5.
Note! The scan will skip any active computer set to 000 in the SCN column.
To stop scanning press F4.
Image tuning - F5
You can tune the image of any remote computer screen from the Select Computer window.
To adjust the screen image:
1. Navigate to the remote computer you wish to adjust.
2. Press F5. The screen image of the selected computer appears, together with the Image Tuning label. See
Figure 2-6.
3. Adjust the image by using the Right and Left Arrow keys.
4. When the image is satisfactory, press Esc.
Note! Picture quality is relative to distance. The further away a remote computer is from the Manager position,
the lower the image quality, and the more tuning needed. So place the higher resolution computers closer to the
manager unit.
The OSD functions
Figure 2-5 The Scan Confirmation label
Figure 2-6 The Image Tuning label
2-7